Phone: (
888) 289-7299
Email: [email protected]
5 |
P a g e
MCS – MicroMag Error / Alarm Manual
Version: 02/21/2020
This status is displayed when the Run/Stop Switch
has been turned off. In this state, all relays are
disabled, and their statuses will read “OFF.”
To enable the Run/Stop, refer to Appendix D.
When the fluid inlet or outlet temperature sensor
reads a value higher than the value of Setpoint #8
(CW
IN/OUT
Target), the unit displays this state and
is starting to or is currently running in order to drop
the fluid temp below the setpoint. For cooling sub-
states, refer to Appendix A.
MicroMag Unit States
OFF RUN/STOP
COOLING
3
.
4
.
