The left switch is for DOOR LOCK when passive arming.
If this DOOR LOCK switch is ON during passive arming is activated,
the car door is locked.
The car door will be UNLOCK state when the left switch is turned off
( located upward ) even though passive arming is activated.
2-18. PROGRAMMING ( CODE RUNNING )
This car alarm system needs programming ( code running ) when the above
installation is finished.
Please follow below procedures.
1). Supply the power into the car alarm system through RED & BLACK wire.
Then, the system is in alarm mode.
2). Put the key into the key box and turn “ACC “ ON and OFF more than 5 times.
Then, the system will be in Valet mode.
3). Press the switch on the base communication module for 2-3 seconds. Then,
the system will sounds 5 chirps and goes into CODE RUNNING mode.
4). Press any button of 2-way remote controller. This will finish
first code running.
You should use 2-way remote controller for the first code running.
5). Press any button of extra remote controller if you have or press any button
of the first remote controller if you do not have extra remote controller.
The second code running is finished now. And the system is in Valet mode.
6). Disable the Valet mode. For example, press button “AUX” for more than
2 seconds during the key located “ACC” in the key box.
The system disables the Valet mode and goes to the disarm mode.
All of code running can be done through the procedures.
Summary of Contents for DTH-3002R
Page 1: ...USERS MANUAL DTH 3002R Operating Instructions...
Page 9: ......
