9
8
HOW TO USE THE SYSTEM
HOW TO USE THE SYSTEM
STARTUP
As you connect the hose to the wall inlet or manually turn on the unit, the Automatik system
starts up in a
progressive manner.
The soft start feature protects the electrical pannel from sudden high tension. At the
same time,
water starts to flow in
from the water jets located in the air inlet of the unit.
GENERAL INFORMATION
As you are cleaning, the vacuum unit gradually fills up and
comes to an automatic stop once water reaches
the electrodes.
While the system is stopped,
the vacuumed content is being evacuated from the unit.
This
can take a
few seconds before the system starts back again
(refer to page 6 and 7).
NOTICE:
Disconnecting the hose from the wall inlet stops the system, which
opens the rubber hand and
empties the unit’s content.
LIQUID PICK-UPS
Instead of the regular floor brush, use a tool specially designed to vacuum liquids.
If you are using a cleaning kit equipped with jets:
BEFORE STORING AWAY
Cleaning wet surfaces
dirties the inside of the hose.
It is therefore necessary to clean them before storing away the equipment.
Connect the hose
into the wall inlet.
Keep the unit running for a few
minutes as it dries out
Optional: vacuum toilet paper
to accelerate drying process.
Connect the water hose from,
either the cleaning tool or
cleaning wand, to the faucet.
Vacuum 2 gallons
of clear water
Open the faucet, use
preferably warm water.
Fully extend the hose
and undo any loops
These procedures eliminates any leftover liquids and prevents unwanted leaks when disconnecting the hose.
Ignoring these steps might leave you with a bad stench, mould accumulation and even a clogged hose.
TYPE OF UNITS
You have purchased one
of the following models.
Identify the one related to it.
The model number appears
on the technical label stuck
on the left side of your unit.
Technical label
