strona: 8 / 12
Note
Installation of the awning, adaptation and check the proper functioning can only be
done by trained installers team. This team is responsible for the right installation (with
the anchor bolts) readjustment and test run of the awning.
3.6.
Fastening and pulling on the ropes
If you need to pull the awning in a higher level with the aid of ropes must one:
●
Take out from the packaging.
●
Transport ropes must be fastened so that the awning can not slip out.
●
Uniform load distribution (in horizontal position) during the pulling out.
3.7.
Required tools
●
Ladders / Scaffold,
●
Ropes,
●
Measuring tape,
●
Impact drill and drill bit (depending on the substrate),
●
Allen key (5mm, 6mm),
●
Wrench/ring spanner SW10, SW13,SW17 + SW19 and relevant fasteners,
●
Socket wrench, extended SW13,SW17 + SW19,
●
Tools for the chosen installation method (type of anchor, etc),
●
Screwdriver.
3.8.
Installation Stepps
Note
Installation of awning or adjustment can be made only by trained installation team.
3.8.1. Check the delivery.
3.8.2. Mark and fix the mounting brackets.
3.8.3. Drill a cable conduit for electric line (only for motor drive).
3.8.4. To install guide rails to the brackets, put cassette into brackets and secure it with screws.
3.8.5. Screw front profile to the trolley and check the operation of the awning.
3.8.6. Connect motor of awning to the power supply (only for motor drive).
3.8.7. Handle (only for Manual drive or Motor drive with NHK).
3.8.8. Check the unit.
3.8.9. Training and information the end user before using the awning.
3.8.10. Handing over all the necessary instructions and warranty the end user and pass the awning for use.
3.8.1. Check Delivery
Before beginning the installation should be checked:
●
Check that the information given in the order of: awnings, color and pattern on the fabric, frame color,
type of drive (handle/motor), drive side and the other product features are consistent with the
delivery.
●
Number and accuracy of the delivered parts.
3.8.2. Marking and fixing of the mounting brackets
CAUTION!
In order to avoid the risks associated with moving parts of the awnings, device must
be installed at such a height that the lowest moving part will be at least 220 cm from
the ground.
