strona: 10 / 12
3.8.6. Connect an awning motor to the power supply (if motor ordered)
CAUTION!
The electrical connection must be made by a licensed professionals. Electrical cables
connect as described in the attached schematic. The awning may be connected only if
the information on the rating plate agree with the power source.
When installing the motor cable make sure that no creases and sharp edges on the cable line. The
uninterrupted operation of the motor driven by electrical outlet is not allowed! The switch of the awnings
should be installed at a height of 125 cm and must be locked for off and on position, otherwise the end point
position is lost. The unroll and rollup limits are the factory setting. After changes to the settings, save them
according to description in manual.
●
End point position of the motor.
To make a change in the end point position, use the description of supplied motor.
When weared or damaged cables, do not use awning and repair by a licensed professionals.
3.8.7. Using a handle (only manual drive or motor drive with NHK)
●
Hook the handle to the awning. Turning the handle you can roll up and unroll the awning.
3.8.8. Check the awning after installation
After installation, check items from the list below:
●
Operation (manual or electric).
●
Stability.
●
Proper operation of limit switches.
3.8.9. Training and instruction of the end user before awning in use
Installation team must fully inform the end user about safe use of the awnings.
3.8.10. All manuals, as well as installation and setting instructions of the motor, switches and
controllers must be given to the user
After properly assembly, responsible person signs the The handing over protocol/Waranty. He is also
responsible for determining the final wind class of the awning and write it in the Warranty. After assembly,
depending on the installation conditions the wind class of the awning can be lowered relative to the nominal
class. Changes must be confirmed by stamp and signature.
The handing over protocol/Waranty must be countersigned by the user and installation team.
After assembly the following instructions must be passed to end user:
●
Installation manual,
●
Service and maintenance manuals and warranty (with wind class of the awning),
●
Settings (only for motor drive),
●
Sun and wind automatic instruction (only for awning with automatic),
●
Remote Control Guide (only remote controled awnings),
●
Handing over protocol/Waranty.
3.9.
Repair the awning
Repairs should be carried out only by a specialist. Only spare parts from DRAGON
can be used.
