24
Dräger WorkMaster Industry
Disposal
4. Store the chemical protective suit in a dark, cool, dry and
airy place without pressure or stress. Keep out of UV light
and direct sunlight; avoid ozone.
Observe the storage temperature (see Chap. 9 on
Page 24).
For stationary storage:
Store the chemical protective suit flat.
or
Hang up the chemical protective suit; hood or protective
boots must be in contact with the ground.
For storage in a utility vehicle:
1. Fold up the depressurized chemical protective suit
carefully:
Do not bend the suit material, seams and fastener system
in the process.
a. Turn up the protective boots twice.
b. Place the sleeves into the centre of the chest section.
Smooth out any creases.
c. Place the head section over the rolled up trouser legs.
2. Store the chemical protective suit in a carrying bag or lying
flat in a storage bay. Avoid wear due to constant friction
against the storage surface.
8
Disposal
8.1
Withdrawal from service
The chemical protective suit must be withdrawn from service in
the following situations:
It has been damaged and repair is not possible.
It was contaminated and cannot be decontaminated
anymore due to the characteristics of the hazardous
substance.
The suit material has altered: there are visible embrittled
areas, bulges, colour changes, softened areas on the
surface, for example.
In case of doubt please contact Dräger for more information.
8.2
Service life
If unused and if the recommended storage conditions and
maintenance intervals are met, the material properties of the
chemical protective suit are retained for at least 10 years from
the data of manufacture. The service life may be reduced
despite correct storage and servicing if the suit is used
frequently.
8.3
Disposal instructions
The chemical protective suit must be disposed of in
accordance with the applicable regulations.
9
Technical data
9.1
General
Sizes in cm:
Resistance of the suit material
NOTICE
The chemical protective suit can be disposed of
thermally or on waste dumps. The type of disposal
depends on the contamination.
i
i
Suit size
Body
height
Chest
circumference
Waist
measurement
M
160-175
80-118
72-106
L
170-185
80-118
72-106
XL
180-190
104-124
95-110
XXL
185-200
104-124
95-110
Weight:
with integrated full face
mask and boots
approx. 6.5 kg
Material:
Chemical protective suit
SYMEX
Gloves
FKM or
Butyl
Overgloves
K-MEX
®
Gigant: Kevlar
or
Tricotril
®
: Nitrile/Kevlar
Safety boots
Nitrile:
black, FPA-CR safety boots
or
PVC: yellow, safety boots
Full face mask visor:
polycarbonate
Colours:
Outside/inside
red-orange/grey
Zip:
vertical on the back, outside zipper
mechanism
Temperatures:
During use
-30 °C to 60 °C
1
1
Tested by Dräger
During storage
-5 °C to 25 °C
Test
Result
Class
1
1
according to EN 943-1:2015+A1:2019
Abrasion resistance
>2000 cycles
6
Flex-cracking resistance
>40000 cycles
5
Flex cracking resistance at
-30 °C
>200 cycles
2
Tear resistance
>40 N
3
Penetration resistance
>50 N
3
Resistance to flame
penetration
self-
extinguishing
fulfilled
Seam strength
>500 N
6
Tensile strength
>1000 N
6
