Dräger Multi-PID 2, User Manual

Page: 27 / 107

27
Using the Multi-PID 2
Charging the Battery Pack
To charge the battery pack:
1. Plug the AC adapter into the jack located on the bottom of the
Multi-PID 2.
2. Plug the AC adapter into an AC outlet. If you are using the Euro-
pean AC adapter, ensure the correct plug is installed on the line
cord. If it is not correct for the wall outlet in your area, then it must
be replaced.
3. The Charge LED on the Multi-PID 2 indicates the charge state.
Red indicates the battery is being charged. Green indicates the
battery is fully charged and ready for use.
It is normal for a fully charged battery to indicate it is charging (red
light) when first plugged in. The Charge LED will turn green within
a few minutes to indicate the battery is fully charged.
4. When the battery pack is fully charged, remove the AC adapter
first from the wall outlet and then from the Multi-PID 2.
Figure 4 – Battery Pack Removal and Replacement
NOTE:
Only use the AC adapter specified for use with the Multi-PID 2.
Using another AC adapter will result in damage to the battery
pack, the Multi-PID 2 or the adapter itself.
0082395
7_0
1_de.eps