Spare parts for SD5-1 and S1001N-1
S E R V I C E T I P S
Before working on machine disconnect from power
supply by removing plug from socket.
Wear protective glasse s!
* o p t i o n a l
1 . One drop of oil between knife (11) and head-casting (1) keeps the
spacing shims (15) in place.
2 . Dismantle Spring cover (20) and take spring out (19).
3 . Take circlip (16) and was her (17) off.
4.
Push knife pin (18) out of casting.
5.
Take knife out of housing
6.
Attention, do not exchange the spacing shims (15).
7.
Place the knife inside the housing feed shims in on one side and
push knife pin (18) into housing up to the middle of the knife.
8.
Feed the shims on the other side of the knife.
9.
Push knife pin in completely, and secure washer (17) and circlip
(16) again.
10. Assemble spring (19) and spring cover (20).
11. Between the knife (11) and the jaws (10) should be some
distance, approximately 0,1 mm on each side. Knife (11) must be
placed tight in the head casting.
12. Adjustment for the play between the jaws. (a): 0,1 - 0,15 mm.
1 3 . If knife has contact with the jaws on both sides, adjust with screws
in the head casting.
If a burr is on the material, adjust the space between the knife and
the jaws.
