20
DR
®
PRO-XL CHIPPER SHREDDER
Grease Fittings
Your PRO-XL CHIPPER-SHREDDER was greased at the Factory. The operator
needs to lubricate the Chipper Side and Drive Side Bearings every 40 hours of
use.
Tools and Supplies Needed:
Flexible hose grease gun
Lithium grease
Clean cloth
1/8" Allen Wrench
1.
Remove the Grease Fitting Protective Cap (
Figure 20
).
2.
Wipe all dirt, etc., from the Grease Fitting(s) with a clean cloth.
3.
Apply no more than three pumps of quality general-purpose lithium grease
with a hand-pumped grease gun to each Grease Fitting, one on the Chipper
Side Bearing, and one on the Drive Side Bearing (not shown). To access
the Drive Side Bearing, you will have to remove the Belt Guard (see Drive
Belt Maintenance section).
4.
After greasing, check the Side Bearing Collar Set Screws for tightness with a
1/8" Allen Wrench. There are two Set Screws per Bearing
5.
Replace the Grease Fitting Protective Cap.
Checking the Tire Pressure
Tools Needed:
Tire Pressure Gauge
Air Compressor with hose
1.
Remove the Valve Stem Cap (
Figure 21
).
2.
Check the Tire Pressure per the manufacturers recommended pressure
stamped on the side of the Tire using a Tire Pressure Gauge.
3.
If the pressure is too low, add air through the Valve Stem using an Air
Hose.
4.
Replace the Valve Stem Cap.
Over lubrication can damage Bearings.
Valve Stem
Cap
Figure 21
Do not over inflate the Tires. Inflate to the manufacturers recommended
pressure found on the Tires.
Side Bearing
Collar Set
Screw (2 places)
Grease Fitting
Protective Cap
Figure 20
Side Bearing
Grease Fitting
