CONTACT US AT
www.DRpower.com
11
Valve Stem
Protective Cap
Figure 12
Connecting the Battery Wire
We ship all Electric-Starting Mowers with the negative terminal Battery wire
disconnected. This prevents the Battery from discharging during shipment.
Before using your Mower, you must connect the Battery wire.
1.
Connect the negative (black) wire to the negative terminal on the Battery by
sliding the Connector onto the Terminal
(Figure 9
).
Adding Oil and Gasoline
Note:
Please refer to your Engine Owner’s Manual for detailed oil information
regarding Oil weight based on ambient temperature
1.
Place the machine on a level surface and initially add 1/2 of oil
recommended by the Engine manufacturer into the Oil Fill (
Figure 10,
Electric Start Machines
) or (
Figure 11, Manual Start Machines
).
2.
Wait one minute for the oil to settle and check the Dipstick. Continue
adding a few ounces of oil at a time, rechecking the Dipstick until the oil
reaches the full mark. Be careful not to overfill.
3.
Fill the Fuel Tank to not more than 1/4" from the bottom of the Fill Neck
with fresh, unleaded gas. See your Engine Owner’s Manual for more
information.
Check the Tire Pressure
Tools Needed:
Tire Pressure Gauge
Air Compressor
1.
Remove the Valve Stem Protective Cap (
Figure 12
) and check the tire pressure with a Tire Pressure Gauge.
2.
Compare the tire pressure reading from step 1 with the manufacturer's recommended tire pressure stamped on the side of the
tire.
3.
If the pressure is too low, add air through the Valve Stem with an air hose.
4.
Replace the Valve Stem Protective Cap when finished.
Oil
Fill/Dipstick
Figure 10: Electric Start Machines
Gas Fill Cap
(except Premier)
Figure 9
Negative
Battery Wire
Battery
You must add Oil before starting the engine. This machine is shipped
without oil. Traces of oil may be in the reservoir from factory testing, but
you must add oil before starting the engine. Fill the reservoir slowly,
checking the level frequently to avoid overfilling.
To get an accurate reading when checking the oil level:
- The machine should be on a level surface.
- The dipstick SHOULD be screwed down on Briggs & Stratton
Engines to ensure an accurate oil level reading.
Before filling the Fuel Tank; turn the Engine OFF, and let it cool at least five
minutes before removing the Gas Fill Cap
Do not over inflate the tires. Inflate to the manufacturers recommended
pressure found on the tires.
Figure 11: Manual Start Machines
Oil
Fill/Dipstick
Gas Fill Cap (Premier Only)
Summary of Contents for 10.5HP PRO-26
