RESETTING LED FILTER LIFE INDICATOR
To reset the LED after replacing the filter, remove the battery holder from the faucet and press and hold the reset button
labeled “SW1” for three seconds. The light will flash RED-BLUE-RED.
If the light does not flash when the Filter Life Indicator is reset, the battery may have died, or been improperly installed.
To replace the battery see Installing and Replacing Battery on page 16.
When the battery is replaced, the LED will flash BLUE-YELLOW-YELLOW-BLUE to signal successful installation.
When the faucet is running, the LED will flash blue.
NOTE:
When replacing the filter, we recommend also replacing the battery at the same time; however, this is not always necessary.
User Manual | 17
Reset button for
Filter Life Indicator
(size of a pinhead)
Code SW1
R2
U2
U1
L1
LED1
C1
LED3
LED2
R1
SW
2
SW1
R2
U2
U1
L1
LED1
C1
LED3
LED2
R1
SW2
SW1
Press and hold the filter reset button labeled SW1
for three seconds until it flashes RED-BLUE-RED
Reset button for Filter
Life Indicator
(size of a pinhead)
Code SW1
