Doyon PIZ3G, Manual

Page: 16 / 57

A14
•
The burner goes to lock-out because of:
a) Flame failure:
b) The spark is irregular or not present:
c) The air pressure switch does not close its
contact.
The burner is equipped with multiple
interlocked safety devices. In the event of a
failure of the flame or any blockage of the
combustion air supply, the burner will "lock
out" in the safety condition.
•
Air has not been bled from the gas line.
•
Porcelain insulators cracked (very little
crack is enough).
•
Spark probe grounded.
•
It may be disconnected, incorrectly set or
defective or maybe the blower is not
running.
Uneven baking Make sure that the grills do not obstruct the air
flow. Do not use foil on the grills.
Verify the temperature of the oven by using an
oven thermometer and make sure that it is even
with the thermostat setting.
If the oven is baking too much on the sides, it is
possible that the fan is not cycling properly.
Verify if the motor turns 2.5 minutes in a
direction, stops 30 seconds and starts for 2.5
minutes in the opposite direction.
If the OVERHEAT WARNING light is on and
you hear the warning buzzer
Check if the cooling fan airflow is not
obstructed.
Check the cooling fan if it is running. If not,
call a qualified technician to replace it.
(Electrical components may be damaged if it is
not repaired immediately.)
Do not allow any obstruction to free the airflow of the burner.
CAUTION
Never try to modify the burner controls. This must be done only by a qualified
technician and under the company's instructions.