Doyon FC18G, User Manual

Page: 14 / 68

A-12
NOTE: In order to remove the conveyor, it is necessary to be two people.
1- Place the oven main switch [A] to the position "OFF" (see drawing next pages).
2- Make sure that the oven has cooled down completely.
3- Disconnect the yellow plug of the conveyor motor [B] (unscrew the plug).
4- Remove the two crumb tray located under the conveyor [C] (lift it approximately 1/2
inch (1cm) and remove).
5- Take out the screws which hold the two finishing plates on each side of the conveyor
[D] and remove the finishing plate. [E]
6- To take out the conveyor, it takes two people, one at each end. The person who is at
the opposite side of the gear motor of the conveyor raises it 1 inch (2 cm) and pushes
it towards the front. When the end of the conveyor is inside the oven, it is preferable
that the same two people place themselves on each side of the conveyor and continue
to pull with precaution to take out the conveyor completely.
7- To re-install the conveyor, repeat the instructions above in reverse.
Note: It is possible to reverse the conveyor. When you are ready to re-install, just enter it at
the opposite side of the oven.
INSTRUCTIONS TO REMOVE THE CONVEYOR
AND CLEAN THE OVEN FC2G
A
B
C C
D
E
6
6