Doyon ARTISAN 1T series, User Manual

Page: 10 / 52

A7
OPERATION OF THE OVEN
1. Turn the switch to the ‘ON” position.
•
The display on the control panel will light.
2. Adjust the thermostat at the desired setting (see THERMOSTAT INSTRUCTIONS below).
NOTE: The digital display must be ON. If not, check the breaker on the inside side of the oven
near the electrical connectors and the main breaker of the oven.
3. Heat the unit until you reach the baking temperature (see preheating time below). The green
light "OK" on the thermostat will light. (If the digital display is on and the oven does not
produce heat, call for service.)
4. If you use the steam, be sure that the light indicator on the steam switch does not flash before
the next step.
5. Load the oven as fast as possible to avoid letting out too much heat.
6. Inject steam if desired.
7. Set the timer to the desired value and start it. (See timer adjustment on next page.)
NOTE: The timer does not shut off the oven at the end of its cycle, it simply activates the buzzer.
THERMOSTAT INSTRUCTIONS
IMPORTANT: Never heat the oven more than 650°F/350°C
To obtain a very good thermal stability, we use a digital temperature controller with thermocouple.
The thermostat controls the heat of the elements to the desired set point “SET”. This temperature
control also has the possibility to adjust the element efficiency percentage to obtain more or less heat
according to the used product. It is possible to increase or decrease the heat produced by the top
elements "A", in front near the door "B" and bottom "C" by using the controls 7 and 8 underneath the
thermostat. It is possible to adjust A, B and C from 0=0% to 11=100% for each element section.
Element "A" (top) base adjustment recommended for:
bread 3 and pizza 3.
Element "B" (front) base adjustment recommended for: bread 4 and pizza 5.
Element "C" (bottom) base adjustment recommended for: bread 3 and pizza 5.
The temperature of the oven is always shown on the display of the thermostat and a red indicator
light "Y" indicates that the oven is in heating mode or a green indicator light "OK" indicates that the
desired temperature is reached.
To adjust the temperature, you have to press the "SET" button and hold it until the numbers flash.
Use the arrows to set the desired value. Press the ‘SET’ button to return to operating mode. The red
indicator light "Y" will light to indicate that the oven is on heating mode, when the temperature is
reached, the green indicator light "OK" will light up.
ECONO MODE
If you select the ECONO mode, the oven element will heat at 60% or 80% to save energy.
Press and hold the ECONO button to change form 60 % or 80%.