PROGRAMMING
1.
Position the gate half way between open/closed. Lock the Arm using the
Key in front of Motor.
2.
Using the buttons (above) on the Control Board, Scroll to
P030
& press
OK
3.
Scroll to
d002
& press
OK.
Display will show
P030
4.
Press the top button three (3) times.
P003
shows on digital display.
5.
Press middle button once (1)
APPr
flashes.
6.
Press & hold the middle button till
APPr
stops flashing.
7.
The gate will fully open & close automatically to find where the Stops
are placed. The gate should finish in the closed position.
8.
This symbol is for ‘Gate Closed’. It shows on screen when
done.
_| |_
If you see this, the ‘Gate Open’ symbol, swap the brown and blue
wires between the terminals.
_ _ _ _
PROGRAMMING IS FINISHED!
Scroll up
Programming
Buttons
OK
Scroll down
Digital
Display
Control Board
8
