Dovre 350CB, Installation Instructions And Operating Manual

Page: 37 / 170

Preparing the connection to
chimney
When connecting the appliance to the chimney you
have the choice of connecting via either the upper
side, the side or the rear. See the paragraphs
"Connecting to the top side or on the side" and
"Connecting to the rear".
The appliance is not supplied with a flue gas
opening.
Sealant and materials supplied.
For Germany, the appliance is supplied with a
connection collar with a diameter of 130 mm.
When connecting to the upper side an opening has
to be made in the heat shield. At the spot when the
opening has to be made an incision has been made
in the heat shield.
Preparation for connection at the
rear side
Make the necessary opening in the heat shield.
1. Unhook the heat shield from the appliance.
2. Make the opening in the heat shield by cutting the
pre-cut section out of the heat shield using plate
shears.
3. Replace the heat shield back onto the appliance.
Connecting to the upper side, rear
side or on the side
First make the flue gas opening in the appliance by
removing the connection cover. Use the equipment
provided: the tension piece, the washer, the nut and
bolt; see following figure.
1. In the centre of the connection cover, drill a hole
with a diameter of 10 mm.
2. Place the tension piece and the bolt on the inner
side of the connection cover.
3. Slide the washer over the bolt and tighten the nut
onto the bolt.
On enamelled appliances, place a piece of
cardboard measuring a minimum of 20 cm by
20cm between the washer and the appliance to
protect against chipping of the enamel.
4. Tighten the nut by hand. Use a small amount of
grease to make it easier to turn the nut.
5. Using a ring spanner, tighten the nut so that the
connection cover breaks out.
6. Once made a flue gas opening can be closed off
again with the supplied shut-off cover (A). Use the
mounting plate (C) and bolt M6x25 (D) to fit the
cover to the appliance (B); see the following figure.
Subject to change because of technical improvements
9