OM-HY/6G(CE) 15
Cleaning
e. Wipe out the cavity. Make sure the drain holes at the back of the cav-
ity are clear of debris.
f.
Hold down the CLEAN button while turning the steamer on. Continue
holding it until the CLEANING indicator light comes on. Then release
the button. After five minutes, the beeper will begin to beep rapidly.
This is the signal to add 500 ml per cavity of Groen De-limer De-
Lime-Away® or equivalent as shown at right.
Do not use any delimer that contains chlorine.
g. Replace fan baffle partition and close door.
h. The cleaning cycle consists of a boiling clean stage, a soak stage, and
a rinse stage. The full cycle takes about 50 minutes to complete.
i.
WEAR PROTECTIVE GLOVES AND EYE PROTECTION FOR THIS STEP.
When the steamer beeper sounds, turn off the steamer and open the
door. After the fan has stopped, remove the fan baffle partition and
rinse it well in a sink. Wipe out the cavity completely. If necessary, use
a damp nylon pad.
j.
Reinstall the fan baffle.
k.
If the steamer will no longer be used, leave it off. Otherwise, wait
10 minutes and turn it back on. When the READY light comes on, the
steamer is ready for operation.
B. If the SERVICE light stays on:
1. Check that the water supply is on and that the supply hose is not
kinked. With the problem corrected, turn the steamer off or 10 sec-
onds and then re-start.
2. Repeat steam generator cleaning.
Once the cavity has cooled down,
reach-in and remove the fan baffle par-
tition by lifting it upward and drawing it
toward the center of the cavity.
Pour 500 ml of Groen de-liming solution
or Lime-Away® into the de-liming port.
The process for de-liming your HY-6G (CE)
Steamer is simple, tool-less and quick.
Summary of Contents for Unified Brands Groen HyperSteam HY-6G
Page 25: ...OM HY 6G CE 25 Electrical Schematic ...
Page 41: ...OM HY 6G CE 41 ...
Page 42: ...42 OM HY 6G CE ...
Page 43: ...OM HY 6G CE 43 ...
