TL 1128 (TOP HOLES)
Issued August 2016
Revision No: 006
Printed in U.S.A.
Copyright 2016, Bayne Premium Lift Systems
Specifications
3
SPECIFICATIONS
WI-0081-A
A. Rotary Actuator - rack and pinion style design.
Rack, pinion, and shaft bearings are constantly lubricated by the hydraulic oil for extended life.
Body and caps are made of high quality ductile iron.
Pinion output shaft and racks are made of high tensile alloy steel.
The rotary actuator provides smooth motion throughout the lift cycle, which results in longer cart life with virtually no
cart damage or abuse.
B. Arm bearings are made of a composite material which provides superior compression strength along with self-
lubrication, thus eliminating the need to grease the arm bearings.
C.The THINLINE
®
lift unit can measure as little as 5” thick from the front of the mainframe to the front of the faceplate
depending on the types of arms used. This allows for easy dumping of large commercial containers without interference.
D.The faceplate is normally at 45 degrees in the dump position and extends 13” to 15” from the back of the mainframe into
the hopper or container opening. This places the cart or barrel 16” to 18” into the truck or container opening thus
reducing any potential spillage of materials.
E. Cycle times for safe, fast, efficient service.
6 - 8 seconds
for rear-load and side-load units
8 - 10 seconds
for units with 9” and 15” vertical lifts
10 - 12 seconds
for stationary, recycling, and double wide, and 24” vertical units
15 - 30 seconds
for 3300 series and 3300 series stationary units
NOTICE
Cycle time is controlled by flowrate, as flowrate increases, cycle times decrease.
WARNING
Never exceed the cycle times listed above. In order to avoid injury and maintain manufacturer’s warranty never operate
outside of these recommendations.
F. Recommended flowrates are as follows:
2 to 2 1/2 GPM
for 1100 series units
2 to 4 GPM
for 2200 series units
2 1/2 to 6 GPM
for 3300 series units
G.Hydraulic pressure requirements are as follows:
2000 to 2500 PSI
normal working pressure
3000 PSI
maximum pressure