Lit. No. 74914, Rev. 01
7
June 1, 2020
STAND SHOE
Initial stand shoe height adjustment is based on
the receiver height measurement (distance "d")
determined in Step 1 under "Pivot Plate Hole Position."
A final adjustment of the stand shoe will be made after
attaching the snowplow to the vehicle.
1. Slide the stand shoe into the stand tube and align
the 1/4" hole in the stand tube with the 1/4" hole in
the stand shoe as determined from the chart and
illustration below.
Stand Shoe Position Chart
Distance "d"
Position
12.75" – 14.0"
1
14.0" – 15.25"
2
15.25" – 16.5"
3
2. Insert a 1/4" roll pin.
3.
Do not cut the spring tie until after the final stand
shoe adjustment.
Roll Pin
Do not cut
spring tie.
Position 1
Position 2
Position 3
WARNING
The stand plunger spring is shipped
compressed and tied. Do not cut the spring
tie until final stand shoe adjustment is
complete and the roll pin is installed.
INSTALLATION INSTRUCTIONS
