51
52
The self monitoring function works in the same way as Back to Base
Monitor-ing except that the
Doss
Alarmfone
sends the alert directly to
you via the telephone line. When the alarm is triggered the security
system sends the alert to the mobile or landline numbers you have
programmed into the Main Unit. When you receive the call from your
security system you will hear an alarm sound indicating the cause of
the alert.
Note:
You will not know which zone is affected. Only a Monitoring Station has
the necessary set up to provide this information.
Step 1:
When you receive a phone call from your alarm system you will hear a siren
sound; the siren will play for 5 seconds and then it will switch off for 5 seconds
(on your phone, but not on the
Alarmfone
at your premises) while the system
is waiting for your response. If you don't press a button within 5 seconds the
siren will come on again for 5 seconds repeating the process.
Press "1" to stop the siren and listen into the room and hear intruder(s).
Press "4" and you will hear the beeps determining the alarm type as shown
above. (E.g., if you hear 3 beeps it means a forced entry alarm alert triggered
by a Door Gap Sensor; see the above table).
Step 2:
Press "2" to arm the system and you will hear a single beep.
Press "3" to disarm the system and you will hear two beeps.
No. of Beeps Alarm Type
1 beep
Tamper (PIR)
2 beeps
Intruder (PIR)
3 beeps
Forced entry (Door Gap)
4 beeps
Panic
8 beeps
Medical emergency
1 long beep Gas
2 long beeps Smoke
Sel f Monitoring
REGISTERING NEW DEVICES
New PIR
5
Additional devices need to be registered (or logged in "login") with the Main
Unit. Unless a new device is correctly registered it will not operate as part of
the security system. This section covers how to register new PIR's, Door Gap
Sensors, Remote Controls, Medical Alert Pendants, Gas Detectors and Smoke
Detectors.
Press the "SETUP" button and enter your four digit password. Press the
"DOWN" button until the LCD screen displays
REGISTER NEW
.
Step 1:
Press the "
#
" key to select the option.
Step 2:
The LCD screen will display
LOGIN PIR
. Press the "
#
" key to select the option
Step 3:
The LCD screen will display
ZONE 1
. Press the "UP/DOWN" buttons to select
the correct
ZONE
.
ZONE
selection must be from
1
to
.
1 LOGIN PIR
2 LOGIN DOOR
3 LOGIN REMOTE
4 LGN EMERGENCY
5 LOGIN GAS
6 LOGIN SMOKE
LOG IN P IR
Mon
PM
DISARM
12:30
10 04
06
Mon
PM
DISARM
12:30
10 04
06
Z ONE 1
REGI STER N EW
Mon
PM
DISARM
12:30
10 04
06
