SAFETY:
1.SELECT A LOCATION:
that is on the water line that chemical injection is desired and meets all
the following requirements as well as all applicable local codes.
Remove Red Caps Prior to Installation.
NOTE:
The entire water line down stream from the injector will have chemical injected into it. If
the chemical injected makes the water unsafe to drink label the water lines.
WARNING NOT FOR HUMAN CONSUMPTION!
2. AN APPROVED BACK FLOW PREVENTOR MUST BE INSTALLED:
In the water line
ahead of the unit to prevent water and chemical mixture from entering the source water supply.
3. AVOID A POTENTIALLY HAZARDOUS CHEMICAL ACCIDENT:
An injector location
should be selected to provide a safe, but accessible, place for the chemical solution container. It
should be kept away from children and/or high usage areas.
4. AVOID SOLUTION CONTAMINATION,
use only clean FILTERED water. Do not allow con-
taminants to enter the solution container because they will be pumped into the water line, and can
cause the spread of disease and
can also cause excessive wear.
5. WATER TEMPERATURE
Max:
100°F or 38°C
Min:
32°F or 0°C
6. MAX WATER PRESSURE
10% - 65 PSI/4,5 BAR
1% - 5% - 100 PSI/6,9 BAR
7. RELEASE WATER PRESSURE:
Before working on injector
4
