Overheating
The blender is equipped with a thermostat to ensure that the appliance has a long service life.
It is activated if the motor becomes overloaded. If the thermostat is activated, turn off the
appliance and unplug it. Wait 30 minutes before restarting the appliance. Clean the parts as
instructed in “Cleaning and maintenance”.
Cleaning and maintenance
Always unplug before cleaning. Important! Always clean the blender jug after use. This is to avoid
the jug discolouring. All parts of the blender jug are dishwasher-safe apart from the blade unit,
which must be washed carefully by hand – note that the blades are very sharp. Carefully dry
all the parts before putting them away. Do not use abrasive cleaning products. Remove any
stubborn stains by soaking and rubbing with a soft cloth and mild detergent. Use a damp clot
when cleaning the motor section. Dry thoroughly before reusing the appliance or putting it away.
You can also clean the blender jug by pouring around 300 ml of water into the jug along with a
few drops of washing-up liquid and then running the ice crushing programme for 30 seconds.
Then rinse the jug carefully with clean water.
Remove the blade unit from the glass jug and clean it separately as follows: Place the glass jug
upside down and twist off the lock ring at the bottom of the jug by turning it anticlockwise.
Lift the blade unit out of the glass jug and clean the unit and the seal with care. The blade uni
can be washed in a dishwasher. Dry carefully afterwards. Note that the blades are very sharp.
Replace the blade unit and seal in the hole in the glass jug afterwards. Secure them in place by
turning the lock ring clockwise. Make sure that you secure the lock ring properly.
Then replace the glass jug on the motor section.
If you want to add other ingredients or liquid during use, you can, provided the mixing
process is stopped before the cap or entire lid is removed. Make sure that the ingredients
to be added are not too thick or too heavy for the motor to process. If necessary, add a
little liquid through the lid if the motor is struggling or stop the mixing process and scrape
the mixture toward the blade using a rubber scrapper
IMPORTANT!
Use tepid water to clean the glass jug after mixing ice cubes, as the jug will be
chilled and hot water may create stress in the glass and cause cracks.
MAKE SURE THAT THE LID AND FILLER CAP ARE BOTH IN PLACE
ON THE JUG BEFORE RESTARTING THE BLENDER!
IMPORTANT! THE MOTOR SECTION MUST NEVER BE IMMERSED
IN ANY LIQUID!
5
