English
Activate remote control/Change remote PIN
Every time the remote control is activated a new PIN code must be set. If the remote PIN
. If the remote PIN
code is forgotten it can be reset to 0000 by doing a reset of the base unit in Base settings.
However everything in the base unit will be deleted. The registration and handset phone
book are however not deleted.
1.
Press
Menu
. Scroll to
Answer machine
. Press
OK
.
2.
Scroll to
Remote access
. Press
OK
.
3.
Scroll to required setting e.g.
Enable
. Press
OK
.
4.
Enter the remote PIN code (0000 on delivery). Press
OK
.
5.
Enter the new remote PIN code. Press
OK
.
6.
Repeat the new remote PIN code. Press
OK
.
Remote activation
If you have forgotten to turn the machine on, you can do so by remote access.
1.
Call the answer machine. It will answer after 10 rings (Australia 16 rings).
2.
Enter the RemotePIN code (see previous page). One beep confirms correct code.
3.
Any new messages are played back, or press
1
to stop.
4.
Press
0
(off=2 beeps, on=1 beep).
5.
Hang up.
Remote control
This machine can be remote controlled using the keys of an ordinary tone dialling phone.
1.
Call the answer machine.
2.
Press
*
when the outgoing message is played.
3.
Enter the RemotePIN code (see previous page). One beep confirms correct code.
4.
Any new messages are played back, or press
1
to stop.
5.
Select a remote control command, see below.
6.
Hang up.
Command
Function
1 .......................... Stop
2 .......................... Play all messages
3 .......................... Play new messages
4 .......................... Repeat/skip to previous message
5 .......................... Erase single message during playback
6 .......................... Skip to next message
7 .......................... Select answer mode (normal=2 beeps, only otg msg=1 beep)
8 .......................... Playback of outgoing message
9 .......................... Record new outgoing message, Stop=#
0 .......................... Turn TAM off/on (off=2 beeps, on=1 beep)
Please note!
If the machine doesn’t respond to the remote control commands, try pressing the telephone
buttons for a longer or shorter time. In normal cases, the answer machine should react to tones
approximately 0.5 – 1 seconds in length, but longer tones may be necessary in certain telephone
networks.
