FAL.OM.002372.DRM
Page 19 of 62
Version 1.6draft2
Doremi Labs
3 Installation
Follow the steps below to set up the AccessLink and Fidelio System.
For the connection diagram, please refer to Section 10.
3.1 Charging Station/Tablet
You will need to first connect the touchscreen tablet to the Fidelio
Charging/Configuration Base using the tablet bracket.
3.1.1 Connection of the Tablet Bracket to the Configuration/Charging
Station Base
Place the Fidelio Configuration/Charging Station Base upside down near the edge of a
table so that the Tablet bracket can hang down and sit flush with the bottom of the base.
Line up the four (4) holes of the tablet mounting bracket to the four (4) holes of the
Charging/Configuration Base.
Using a Phillips screwdriver, carefully secure the Tablet Mounting Bracket to the
Charging/Configuration Base using the four (4) M3x6 Black Flat Head Machine Screws
provided.
3.1.2 Installation of Tablet into the Stand Bracket
Turn the Fidelio Configuration/Charging Station Base over so that it is sitting upright.
Loosen the Tablet Clip screws.
Slide the Touchscreen Tablet from the right-hand side of the Bracket grooves until the
Tablet is centered on its mounting bracket.
Tighten the Tablet Clip Screws to secure the Touchscreen Tablet in the bracket (Figure
14).
