Doosan P260/HP220WYM, Operation & Maintenance Manual

Page: 38 / 66

Operating & Maintenance Manual OPERATION
36 Book: 46553446 (3-15-2010) Rev A
Starting
• Turn the POWER switch to “ON”.
• Turn Power switch to “START” position to crank engine. Hold switch in “START”
position for approximately 5 seconds after engine starts.
NOTICE
Do not operate the starter motor for more than 30 seconds without allowing at
least 30 seconds cooling time between start attempts.
Release Power Switch (it will automatically move to the “ON” position) when the engine starts
and sustains running.
• Allow engine to warm up 5 to 10 minutes.
• Press the “Service Air Button”. Open air service valve(s).
Cold Weather Starting
• Turn power switch to the glow plug position and hold 10 seconds. Then turn to start.
NOTICE
Exercise extreme caution when using a booster battery to start. To jump start:
Connect the ends of one booster cable to the positive (+) terminals of each
battery. Then connect one end of the other cable to the negative (-) terminal of
the booster battery and the other end to the engine block. Not to the negative (-
) terminal of the weak battery.
NOTICE
Do NOT use ETHER !