Doosan AD158TI, Operation & Maintenance Manual

Page: 19 / 294

Safety regulations - 13 -
2.3. Regulations Designed to Prevent Damage to Engine and Premature Wear
(1)
Never demand more of the engine than it was designed to yield for its intended purpose. Detailed informa-
tion on this can be found in the sales literature. The injection pump must not be adjusted without prior writ-
ten permission of DOOSAN.
(2)
If faults occur, find the cause immediately and have it eliminate in order to prevent more serious of dam-
age.
(3)
Use only genuine DOOSAN spare parts. DOOSAN will accept no responsibility for damage resulting from
the installation of other parts which are supposedly
″ just as good ″ .
(4)
In addition to the above, note the following points.
●
Never let the engine run when dry, i.e. without lube oil, fuel or coolant. Use only DOOSAN approved
service products. (engine oil, anti-freeze and anti-corrosion agent)
●
Pay attention to cleanliness. The diesel fuel must be free of water. See ″ 4.6. Fuel System ″ .
●
Have the engine maintained at the specified intervals.
●
Do not switch off the engine immediately when it is warm, but let it run without load for about 5 minutes
so that temperature equalization can take place.
●
Never put cold coolant into an overheated engine.
●
Do not add so much engine oil that the oil level rises above the max. marking on the dipstick. Do not
exceed the maximum permissible tilt of the engine. Serious damage to the engine may result if these
instructions are not adhered to.
●
Always ensure that the testing and monitoring equipment (for battery charge, oil pressure, and coolant
temperature) function satisfactorily.
●
Do not let the sea water pump run dry. If there is a risk of frost, drain the water when the engine
switched off.