12
proGrammInG of remote controls
8. proGrammInG of remote Controls
1.
memory cleaning. To erase the codes from the memory press the “Tr” button and hold it down for 10 seconds. After that
you will hear a click and two zeros will appear on the display, meaning that all the remote control codes are deleted.
2. control’s code storing. To store the remote control code, press the “Tr” button and release it after two blinking zeros “00”
appeared on the display. Than select a button on the remote control, which you will use to control the unit, and press
it. The amount of the remote controls recorded in the receiver will appear on the display, for example “01”. release the
button. Wait until a running zero “0” will appear on the display, meaning that a remote control has been recorded.
3. To add several remote controls, repeat the procedure of code storing for them. you can add 60 remote controls.
4. If no control commands are given, the system will automatically exit from the waiting mode in 10 seconds. Should the
control unit disconnect from the mains, the programmed data will be stored.
9. release operatIon
1. lift the cover.
2. Insert the key and turn it by 180°
3. Open or close the gate by hand.
4. To link the operator, turn the key by 180° again.
WarnInG!
Before releasing (linking) the operator, disconnect power supply.
Key
cover
180°
10. maIntenanCe
The Swing-3000/5000 automatic system does not require any special servicing.
repairs may be carried out only by a qualified technician trained and certified at an authorized doorhan centre.
Be sure that after completion of installation the installer has shown the user how to release the door in case of emergency
and has given instructions on proper operation and maintenance of the automated system.
When carrying out maintenance, it is recommended to use doorhan original spare parts.
carry out maintenance of the automatic system at least every six months.
regularly check if the door is properly balanced and moves smoothly when automatically operated.
regularly check if the extreme positions of door travel are properly adjusted and safety devices are in good working
condition.
In case of power failure you may need to restore operator’s settings. Once the power supply is restored, check the
automatic system for proper operation. If the operator settings have changed reprogram them following the instructions
given in the corresponding paragraph of this manual (pay special warning to Operation time programming).
In case of power failure the door will stop. As soon as power supply is restored you can control the operator as usual.
After expiration of life time, the item shall be delivered in a specialized disposal point!
If you have lost this manual, you may request for the duplicate copy to the following address: Kralovsky Vrch 2018,
Kadan, 43201, czech republic, or by e mail: [email protected].
The producer (doorhan) does not supervise the installation of operators, or carry out their maintenance, thus doorhan
cannot be held liable for safety of installation, operation and maintenance of the equipment.
Summary of Contents for SWING-3000
Page 14: ...14 Notes ...
Page 15: ...15 Notes ...
