DoorHan SWING-3000, Installation And Operating Manual

Page: 7 / 16

7
operator InstallatIon
4.3. InWard Gate openInG
WarnInG! make sure, that the dimension c does not exceed the value indicated in the table below. Otherwise it is
necessary to improve the pole according to the indicated dimension value.
D
Pole
Hinge Gate leaf (closed)
opening angle a, mm B, mm C
макс
, mm d, mm
90° 130 130 60 720
120° 130 110 50 720
opening angle a, mm B, mm C
макс
, mm d, mm
90° 200 200 120 920
120° 200 140 70 920
swing-5000
swing-3000
Mounting plate
Mounting plate
Front bracket
Building level
Rear bracket
Moving
end part
D
A
B
1) fasten the rear bracket with the appropriate fastening plate to the pole, as shown in the picture above, observing
dimensions A and B, namely, the distance between the axis of the bracket’s central hole and of the gate hinge shank. The rear
bracket has several holes, which make installation of the operator easier and allow changing of the gate opening angle. depending
on the position of the gate hinges you can lengthen or shorten the rear bracket.
WarnInG! Increase of dimension B results in decrease of the gate opening angle and leaf angle speed, and in increase
of the operator’s linear force. Increase of the dimension B results in increase of the gate opening angle, leaf angle speed,
and the operator’s linear force.
2) Install steel end piece and lubricate all the parts with neutral grease.
3) When the gate is closed, install
the mounting plate on the gate leaf. make
sure, that the front bracket is positioned
horizontally on the same level with the
rear bracket and that the dimension d
has been observed.
Mounting plate
Mounting plate
Front bracket
Building level
Rear bracket
Moving
end part
D
A
B