DoorHan DRIVE SHAFT-50PRO, Installation And Service Instruction

Page: 14 / 18

14
REMOTE CONTROL DESK PROGRAMMING
9. DRIVE MANUAL OPERATION
Electrical drive SHAFT-50PRO / 85PRO is equipped with manual chain reducing gear which is used in case of emergency
lifting/lowering of gate if the power is switched off. For emergency operation it is necessary to pull the rope with red handle down
to stop excluding the possibility of automatic start of electrical drive. In order to return to the automatic operation it is necessary
to pull the rope with green handle down to stop.
CAUTION! It is forbidden to pull the red handle when the drive is working. This will cause the motor damage.
CAUTION! The continuous intense usage of manual chain reducing gear is forbidden. Usage is permitted in case of
emergency
CAUTION! Before using the manual chain reducing gear ensure that the chain links are not deformed and contaminated.
Otherwise the using of reducing gear can cause its jamming.
If necessary the gate can be opened with the help of chain. Make the chain
longer or shorter so that in the assembled condition its end was at a height
of 50-150 cm from the floor. It is recommended to fix the lower part of chain
in order not to allow the chain to create the obstacles for the movement of
people and equipment. In addition, place in a prominent location the warning
stickers showing the opening and closing directions.
Secure the chain Secure the cords
CAUTION! Use the chain only when strictly necessary, otherwise the
parts of chain reducing gear can be damaged.
10. MAINTENANCE
• Automatic system SHAFT-50PRO / 85PRO does not require special maintenance.
• Only the competent personnel trained at the authorized DoorHan center shall perform the repair and maintenance.
• After the automatic system installation the installer shall demonstrate the user how to unblock the gate in case of
emergency and transfer the data on the maintenance and operation of automatic system.
8. REMOTE CONTROL DESK PROGRAMMING
8.1. Recording of DoorHan desks into receiver
• Press and hold the “R” key until the indicator (dot) in the bottom of display will light up. Release the key.
• On the control panel select the key which in future will be used for the drive operation and press it twice.
• Repeat the operations for the other desks (maximum number is 25 pcs.)
Desk operation mode: OPEN STOP CLOSE STOP OPEN
8.2. Receiver memory cleaning
To delete the desks from receiver’s memory press and hold the «R» key for 8 seconds
until the indicator (dot) in the bottom of display will blink off. At that short audio
signal will be heard.