Installation, Operation and Maintenance manual
12
DFPRE Large Dust Collectors
Cyclopeel / spark trap assembly
For collectors supplied with a cyclopeel pre-separator or a spark trap:
Refer also to figure 7.
1. Remove one column of filter cartridges from right-hand side of collector.
2. Using a two-point lifting arrangement lift cyclopeel / spark trap section.
3. Apply a continuous 5 mm bead of sealing compound to mounting surface of
cyclopeel / spark trap section, along each side of hole pattern.
4. Lift cyclopeel / spark trap section into position and align bolt holes.
5. Bolt cyclopeel / spark trap section to side of collector.
The bolts in area 1 are fastened from inside the clean air chamber.
The bolts in area 2 are fastened from inside the contaminated air
chamber.
The bolts in area 3 are fastened from inside the contaminated air
chamber, through the contaminated air inlet.
6. Mount leg underneath cyclopeel / spark trap section.
7. Anchor leg underneath cyclopeel / sparktrap section.
1
3
2
Figure 7: Cyclopeel / spark trap assembly
Optional fan box assembly
For collectors supplied with a fan box:
Refer also to figure 4.
The outlet position can be changed from the side to other rear by swapping
the grill and cover before mounting the fan box.
1. Apply a continuous 5 mm bead of sealing compound to mounting surface of
collector, along each side of hole pattern.
2. Using a four-point lifting arrangement, lift fan box into position and align bolt holes.
3. Bolt fan to the collector
