19
E N G L I S H
CONSOLE FC 100
INSTALLING THE BATTERIES
1. Remove the console from its holder, take the battery compartment lid
off (located on the rear of the product) and insert two AA or UM-3
batteries in the battery compartment behind the screen.
2. Make sure the batteries are installed correctly and are flush with the
springs.
3. Put the battery compartment lid back on and check to ensure that it
is secure.
4. If the display is illegible or partial, remove the batteries, wait 15
seconds and then put them back in.
5. If you remove the batteries, the computer memory is erased.
RECYCLING :
Batterij vrijgesteld van
milieutaks. Inleveren bij
een Bebat-inzamelpunt.
Pile exonérée d’écotaxe.
A retourner à un point
de collecte Bebat.
B
E
B
A
T
B
The “crossed-out bin” symbol indicates that this product and the batteries it contains
cannot be disposed of with household waste. They are subject to specific sorting.
Take the batteries and your unusable electronic product to an authorised collection
area for recycling. Recycling your electronic waste will protect the environment and
your health.
- If you note that your counter does not display the correct units of distance, check that the switch at the rear of the console is in Mi position
for a display in miles and Km for a display in kilometres. Remove and replace the batteries for the change to take effect.
- If you note abnormal distances or speeds, check the switch at the rear of the console is in the VM position for a bicycle.
On magnetic bicycles, each turn of the pedals corresponds to a distance of four metres; on elliptical bicycles two movements correspond to a
distance of 1.6 metres (these values are average values when riding a bicycle or walking).
- If the heart rate indicator does not flash or is flashing erratically, check that your hands are positioned properly and that the sensors are
not too moist.
TROUBLESHOOTING
Speed:
This function displays an estimated speed.
This distance may be either in km/h or mph, depending on the
position of the switch on the rear of the product.
Distance:
This function indicates estimated distance covered since the begin-
ning of the workout.
This distance may be displayed either in km or miles, depending on
the position of the switch on the rear of the product.
Time:
This function indicates the time elapsed since the beginning of the
workout.
This is indicated in “Minutes: Seconds for the first hour, then it swit-
ches to “Hours: Minutes”.
After 10h the counter is automatically reset to 0.
Calories:
This function displays an estimation of calories expended since the
beginning of the session.
Heart rate*:
Place the palms of your hands on the pulse sensors; after a few
seconds the heart rate indicator will flash and your heart rate will
be displayed in beats per minute.
*IMPORTANT: this is only an estimate, which should in no circums-
tances be considered medically reliable.
IMPORTANT: For several dozen seconds or when there is a rapid
change in heart rate, the value displayed may not match your actual
heart rate.
This is due to the mechanism starting up.
FUNCTIONS
