21
DUAL CLIMA R
6.3
Heat Pump fastening
The heat pump should be firmly fixed to a base, preferably a concrete base.
Fasten it firmly using 4 sets of M12 bolts suitable for the base material, with nuts
and washers (available on the market). Make sure that the protruding distance
of the bolt does not exceed 10 mm inside the metallic support of the device
(leg).
The receiving surface of the device must:
•
Allow a solid fixation (preferably concrete).
•
Fully support its weight.
•
Have a permeable area below the condensate drainage hole (earth, gravel bed, sand, etc.).
•
Do not transmit any vibration to the home, recommending the installation of the antivibration
dampers supplied with the heat pump.
In case of installing the device on wall mounts, it will be especially important to isolate the machine
from the transmission of vibrations and noise inside the house, it may be necessary to install more
suitable antivibration dampers for the wall mount in addition to those supplied with the heat pump.
Nevertheless, the installation on the ground is the most advisable.
Straighten
the heat pump well to ensure that the condensate water cannot exit through any paths
other than the intended drain hole.
6.4
Condensates Drainage
In normal operation, the heat pump can evacuate large amounts of water, for which the DUAL CLIMA
heat pump provides a hole in the bottom of the appliance. Be sure not to obstruct this hole during the
installation process of the appliance.
A
B
A
: Condensates drainage hole.
B
: Front (discharge side).
Preferably install the device in a well-drained place. To do this, it is advisable to
provide a bed of gravel, sand or similar materials below said hole. If the drain hole
of the heat pump is covered by a mounting base or by the floor, lift the unit to
leave a free space of at least 100 mm below it.
If it is installed on a terrace or façade, the condensate outlet must be led to a
drain to avoid inconvenience and/or damage caused by the dripping of
condensate water. If the installation is carried out in a region where the
temperature can be below 0 ºC for a long period of time, check that the presence
of frost does not represent any danger.
Summary of Contents for DUAL CLIMA R
