5
NOTE: DO NOT LEAVE THE STEAM CLEANER UNATTENDED
DURING THE HEATING-UP PERIOD.
Retaining lug
Aperture
Tool release
button
SWITCHING ON AND OFF
Mains Power
Plug the 3-pin mains plug into the mains supply.
The Indicator light will come on to show that the steamer is heating the
water.
Steam will be available after approximately 3 to 4 minutes.
The steamer will provide continuous hot steam for approximately 20
minutes for each fill of the tank. (650ml).
To switch Off, unplug the power cable, the Indicator Light will go out.
USING THE STEAM CLEANER
Fitting the Accessory Tools
The tools can be fitted directly to the Gun, or to the end of the extension
tubes. The two extension tubes can be fitted together to give extra reach if
required.
To fit the tools or extension tubes first make sure that the aperture in the
tool is aligned with the retaining lug on the Gun (or extension tube if fitted).
Push the tool or extension tube onto the end of the Gun (or extension tube
if fitted) until it clicks into place and is held by the retaining lug.
To remove a tool or extension tube from the Gun, press and hold the tool
release button and pull the tool off.
