ASSEMBLY INSTRUCTIONS
1
3
2
Loosen the collar clamp and slide it
up. Push the bars onto the HIC
compression until its bottom touches
the headset cap.
Before placing the bars, using a 6mm
Allen wrench check that the HIC
compression is tightened securely
and the headset is not shaking.
With the front wheel pointed straight
ahead, the bars square to the wheel
and the Dominator logo facing the
front, Use the 6mm Allen wrench to
tight the clamp as shown. Tighten
each bolt securely.
Failure to properly install and tighten
the collar clamp may cause the rider
to lose control and fall. If you do not
understand these instructions or the
concept of “tighten securely” seek the
Never fully tighten a single bolt at
once, take turns tightening each bolt
evenly multiple times, until all are
secure.
WARNING
!!
