MAINTENANCE
COMPRESSION
If your bar starts to shake or
move, it means that your
compression needs to be tighte-
ned. Tighten as explained in the
Assembly Instructions.
We also recommend to tight the
compression just enough to keep
the headset spinning smoothly,
then tighten the bolts of the
clamp well (no too tight though
or it will strip). Be aware to check
your compression (as all other
bolts/axles) on a regular base.
CLEANING YOUR SCOOTER
Wipe with a damp cloth to
remove dirt and dust.
Do not use industrial cleaners or
solvents as they may damage the
surface.
WHEELS AND BEARINGS
Under normal circumstances and
conditions Eagle Supply® Wheels
and bearings are maintenance
free.
Do not allow water to penetrate
the bearings as they will rust.
Lubricating your bearings can be
done by taking off your wheels,
using a dry cloth to remove dirt
from your bearings and wheels,
remove the bearing rubber seal
carefully by using the tip of a
sharp knife and lift the seal on the
edge of the seal. Use 1 or 2 drops
the seal carefully. Your bearings
will make some noise just after
cleaning but it will go away after a
short notice.
