Owner Installation Instructions
Dominator
®
23
Final Set Up
34
fi g
Step 24 - Setting of Courtesy Light Time
The courtesy light time can only be adjusted with the
Universal Programmer (PG-3).
Step 25 - Setting the Pet Mode position
The default Pet Mode height can be changed as follows:
Make sure the door is closed, then press and hold
the PLUS (+) button for six (6) seconds
(Fig.34)
until you hear three beeps and the OPEN and
CLOSE LEDs fl ash rapidly.
Press the PLUS (+) or MINUS (-) button
to move
the door to the desired pet mode open position.
Press the SET button to record the new position.
When activated, Pet Mode drives the door to the preset
position from either above or below. Pet Mode’s active
status is indicated by both the OPEN and CLOSE LIMIT
LEDs being illuminated. If a Pet Mode button is pressed
while the door is moving the door will stop. If a Pet
Mode button is pressed when the door is in the Pet
position, then the door will close.
Step 26 - Installing the Wall Mounted
Transmitter (Optional)
Remove the faceplate from the transmitter.
Affi x the baseplate in a convenient wall location
that is out of reach of children and convenient
to the customer
(Fig.35).
Make sure the door is
visible from this location.
Replace the faceplate.
To code the transmitter, see Step 19 on page
20.
Step 27 - Re-initialising the Opener
Press and hold the SET Button for two (2) seconds,
the beeper will sound once
(Fig.36).
The door will start to move and re-calculate force
margins. The door can move between the open and
close limit positions up to four (4) times (depending
on the position of the door and the power up
condition).
A single beep will be heard once the initialisation is
complete. The door is now ready for use.
a.
b.
c.
a.
b.
c.
d.
a.
b.
c.
35
fi g
36
fi g
