19
EN
Parking Cooler
Using the Parking Cooler
10 .5 Using the Air Conditioner
1. Set the required temperature. Refer to “Setting the
2. Set the required mode. Refer to “Setting the Mode”
on page 19.
I
If the required temperature is not reached in the
energy-saving mode or at a low fan speed, increase
the fan speed or switch to BOOST mode or to
AUTO mode.
3. Set the timer if you want the parking cooler to switch
off automatically after the required time.
10 .6 Setting the Temperature
I
Depending on the set unit for the temperature, the
temperature is changed in steps of either 2 °F or
1 °C.
10 .6 .1 Setting the Temperature Using the
Control Panel
1. Press the
List
button until the thermometer symbol is
displayed.
2. Press the
Up
or
Down
button to set the desired
temperature.
3. Press the
List
button to save the value.
10 .6 .2 Setting the Temperature Using the
Remote Control
1. Press the
Temperature Increase
button to increase
the temperature.
2. Press the
Temperature Decrease
button to
decrease the temperature.
3. To save the value, do not press any button for more
than 5 seconds.
10 .7 Setting the Mode
Use this section to set the mode on the control panel or
the remote control.
10 .7 .1 Setting the Mode Using the
Control Panel
To set the mode from the control panel:
1. Press the
List
button until the M symbol is displayed.
2. Press the
Up
or
Down
button to set the AUTO, ECO
or BOOST mode.
3. To set the MANUAL mode see below.
4. Press the
List
button to start the selected mode.
If you want to set the fan speed manually (MANUAL
mode) do the following:
1. Press the
List
button until the fan symbol is displayed.
2. Press the
Up
or
Down
button to set the desired
fan speed. At the same time the MANUAL mode is
started.
3. Press the
List
button to save the value.
If you want to leave the MANUAL mode:
1. Press the
List
button until the M symbol is displayed.
2. Press the
Up
button to leave the MANUAL mode. The
BOOST mode is started.
3. Press the
Up
button once to set the ECO mode.
4. Press the
Up
button twice to set the AUTO mode.
10 .7 .2 Setting the Mode Using the
Remote Control
To set the mode using the remote control:
• Press the
A
button to set the AUTO mode.
• Press the
E
button to set the ECO mode.
• Press the
B
button to set the BOOST mode.
• Press the
Fan Speed Increase
button to increase the
fan speed manually and to start the MANUAL mode.
• Press the
Fan Speed Decrease
button to decrease
the fan speed manually and to start the MANUAL
mode.
• To start the selected mode, do not press any button
for more than 5 seconds.
