13
EN
Parking Cooler
Configuring the System Software
7 .4 Installing the Cover
6
q
w
e
r
18
Installing the Cover
q
Cover
e
M6 Washer
w
10 x 48 Spacer
r
M6 x 100 Screw
1. From inside the vehicle, place the eight 10 x 48
spacers into the four cover mounting locations.
2. Place the cover over the mounting brackets and the
roof opening.
3. Insert the four M6 x 100 screws and the four M6
washers into the four mounting locations in the cover
and tighten the screws. The maximum allowable
torque for M6 x 100 screw is 35 in. lbs (4 Nm).
I
The cover should be flush with the roof of the
vehicle when installed.
8 Configuring the System
Software
Before the system is first operated, the system settings
can be adjusted to suit the various installation conditions.
These adjustments must be made by the installer.
Display
Indication
Parameter
Meaning
Factory
Setting
P.01
Low voltage
Shut-Down
The battery
monitor shuts
Down the
system at the
factory setting
voltage.
11.4 V
P.02
Unit for
temperature
display
The temperature
can be
displayed in
°C or °F.
°F
I
Configuration mode can still be activated if the low
voltage cut-out has switched off the system and
only the residual voltage is available.
8 .1 Entering and Exiting
Configuration Mode
1. Refer to “Understanding the Controls” on page 14
for a list of buttons and button functions.
2. Press and hold the
List
button.
3. Press and hold the
On/Off
button for longer than
three seconds.
4. The parking cooler switches to CONFIGURATION
mode. The display shows “P.01” and the battery
symbol flashes.
5. Press the
Up
or
Down
button to scroll through the
menu to select the desired menu item.
6. Press the
List
button to open the desired menu item.
7. Press and hold the
On/Off
button for longer than
three seconds to exit CONFIGURATION mode.
8 .2 Setting the Low Voltage Shut-
Down Voltage - P .01
The battery monitor protects the battery against
discharging excessively.
