Dometic RainTec RT100, Installation And Operating Manual

Page: 15 / 117

EN
Connecting the RT100 to the electrical power RainTec RT100
14
➤
Press the adhesive surface firmly and at the same time along the entire
rain gutter.
Note on fig. 7
➤
Guide the connecting cable through the existing borehole ( 1 ) above the
upper guide rail ( 2 ) into the vehicle.
Note on fig. 8
➤
Place the connecting cable in the gap above the upper guide rail.
➤
Seal the gap and borehole carefully with sealant so that no water can
enter the vehicle.
7 Connecting the RT100 to the electrical
power
Supplementary to fig. 9
!
I
➤
Connect the lighting with correct polarity to a 12 V
g
supply (rt = red,
sw = black).
Supplementary to fig. 0
➤
Use a switch (accessories) or the LED dimmer FFB 8 (accessories) to
operate the lighting comfortably.
WARNING!
 Only a qualified electrician should connect the lighting to the
electrical power.
 Establish all connections according to the applicable electrical
guidelines.
NOTE
 If present, use a connection that is switched off when the
motor is running.
 If not, insert a lockout switch in the electrical circuit in order to
ensure that no current is transferred to the lighting when the
ignition is activated. Otherwise, the lighting could be switched
on during travel. The lockout switch can be executed via a
break contact relay which is connected to the D+ signal (
1 ).