Dometic PerfectView CAM360, Installation Manual

Page: 16 / 452

EN
Safety and installation instructions CAM360
16
•
Secure any parts of the system concealed by the bodywork in such a
manner that they cannot be come loose or damage other parts or
cables, or impair vehicle functions (steering, pedals, etc).
•
Always follow the safety instructions issued by the vehicle manufac-
turer.
Some work (e.g. on retention systems such as the AIRBAG etc.) may
only be performed by qualified specialists.
A
NOTICE!
•
To prevent damage when drilling, make sure there is sufficient space
on the other side for the drill head to come out (fig.
2
, page 4).
•
Deburr all drill holes and treat them with a rust-protection agent.
Observe the following instructions when working with electrical parts:
A
NOTICE!
•
When testing the voltage in electrical cables, only use a diode test
lamp (fig.
1
7, page 3) or a voltmeter (fig.
1
8, page 3).
Test lamps with a bulb (fig.
1
11, page 3) consume voltages which
are too high and can damage the vehicle's electronic system.
•
When making electrical connections (fig.
3
, page 4), ensure that:
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp-edged ducts without protection
•
Insulate all connections.
•
Secure the cables against mechanical wear by using cable binders or
insulating tape, for example on existing cables.
The cameras are waterproof. However, the seals on the cameras cannot withstand a
high-pressure cleaner (fig.
4
, page 4). Therefore, you should observe the following
instructions when handling the cameras:
A
NOTICE!
•
Do not open the cameras, as this impairs the leak tightness and the
function of the cameras (fig.
5
, page 4).
•
Do not pull at the cables, as this impairs the tightness and the function
of the cameras (fig.
6
, page 4).
•
The cameras are not suitable for use under water (fig.
7
, page 4)!
CAM360-I-DE.book Seite 16 Freitag, 9. Juni 2017 6:50 18