PerfectView
Fitting the camera
EN
13
If you want to attach the lower camera holder with screws when installing
A
➤
Drill the holes, with a Ø of 5.5 mm, at each of the markings.
➤
Deburr all drill holes and apply rust-protection.
➤
Place the insulating plate (fig.
3
3, page 2) on the installation location of the lower camera
holder.
The insulating plate also serves as a seal and paint protection.
➤
Screw on the lower camera bracket with the M5 x 25 mm threaded screws (fig.
7
A, page 4).
Depending on the thickness of the construction, you may require longer threaded screws.
Fastening the camera
➤
Push the camera into the bottom camera holder.
I
➤
Fasten the camera
loosely
with the upper camera holder and the two screws (fig.
7
B,
page 4).
I
Creating a through-hole for the camera connection cable
I
➤
Drill a hole of Ø 16 mm near the camera.
➤
Deburr all drill holes that have been made in the sheet metal and apply rust-protection.
➤
Seal the feed through with the cable sleeve (fig.
4
3, page 3).
NOTICE!
Ensure that nuts cannot be pulled through the body shell when they are tightened.
Use larger washers or metal plates if necessary.
NOTE
Keep in mind that the LDR sensor (fig.
4
4, page 3) should be faced downwards so
that the image is displayed correctly on the monitor.
NOTE
Do not tighten the two screws until you have aligned the camera (see chapter “Check-
ing the function and setting the camera” on page 14).
If necessary, you may have to first install and electrically connect a monitor (see princi-
ple circuit diagram fig.
8
, page 4).
NOTE
If possible, use available openings, such as ventilation grilles, to feed the connection
cables through. If there are no existing ducts, you must drill a hole of Ø 16 mm. Check
beforehand that there is sufficient space on the other side for the drill head to come
out.
CAM301-IO-16s.book Seite 13 Dienstag, 4. September 2018 10:59 10