Dometic FRESHLIGHT FL1600, Operating Manual

Page: 23 / 476

EN
Dometic FreshLight Operating the roof air conditioner
23
Specifying values and transmitting them collectively to the roof air
conditioner
The remote control may not be pointed at the IR receiver (fig.
2
4, page 3) on the
control panel during operation.
Specify the required values on the remote control. Once you have made all your
settings, point the remote control to the IR receiver on the control panel and press
the
SET button. This transmits the data to the roof air conditioner. The roof air
conditioner confirms the receipt of data with a high note.
Switching only the remote control to or from stand-by
In stand-by mode, the remote control display shows only the time.
If the remote control is not pointing to the IR receiver (fig.
2
4, page 3) on the
control panel, you can activate the remote control or switch it to stand-by inde-
pendently from the roof air conditioner:
➤
Press the button.
9.3 Hint for improved use
The following hints will optimise the performance of your roof air conditioner:
•
Improve the heat insulation of your vehicle by sealing gaps and hanging reflective
blinds or curtains on your windows.
•
If the vehicle has been subjected to direct sunlight for a long time: Operate the
roof air conditioner in the “Circulated air” (
) or “Ventilation” ( ) mode with the
windows open for a while before switching on the “Cooling” ( ) air condition-
ing mode.
•
Avoid opening doors and windows as far as possible in the “Cooling” ( ) and
“Heating” ( ) modes.
•
Select an appropriate temperature and blower speed.
•
Align the air nozzles sensibly.
•
Make sure the air nozzles and intake grille are not covered by cloths, paper or
other objects.
FreshLight-O-16s.book Seite 23 Montag, 19. September 2016 6:29 18