7
6. ICE CUBES
Fill the ice tray to 4/5 with drinking water, cover with
the lid and place the closed ice tray on the ice-tray
shelf. Wipe off any excess water to prevent the ice tray
from freezing to the surface.
To speed up the making of ice cubes, turn the
thermostat to position 5 for a short while. Remember
to turn the dial to its normal setting when the ice cubes
are frozen.
To remove the cubes from the ice tray, hold it under
running water. Remove the lid with the ice cubes from
the ice tray and the ice cubes can now be taken out
easily.
7. Useful suggestion
Do not overfill the appliance. It is advisable to leave
some space between the products in the cabinet to
ensure efficient and even cooling. If the shelves are
packed too tightly there may be unacceptable
temperature variations.
8. Defrosting, cleaning and
maintenance
Frost will gradually form on the cooling surfaces and it
must not be allowed to become too thick since it acts
as an insulator and interferes with the cooling.
This frost-formation is kept back by the FUZZY LOGIC
system built into the appliance by switching off the unit
for two hours in every 24 hours. The frost will melt and
the defrost water will run through the drain tube from
the drip channel into an evaporating vessel located at
the bottom rear of the refrigerator. (Fig 5) The defrost
water will evaporate automatically into the circulating
air and the vessel will not need emptying manually.
If we want to switch off the unit, turn the thermostat
knob to "0", disconnect the refrigerator from the
electricity supply and leave the cabinet door open.
After defrosting the cabinet interior should be wiped
out with a clean, damp cloth.
9. Changing the lightbulb
(If available)
If the lightbulb needs changing, pull out the plug and
proceed as follows:
Press the metal reflector to one side and draw the
lamp covering backwards. Replace the bulb and push
the covering back into place.
A new 10-watt bulb can be obtained at any service
shop.
10. Reversing the door hang, Fig. 6
Lay the appliance on its back. Remove the 8 screws
(1). Remove the door, together with the two hinges
(2), from the housing.
Remove the two cover caps (3) from the housing and
place them in the open hinge holes in the housing.
Place the bottom righthand hinge in the top left of the
door and the top righthand hinge in the bottom left of
the door and hang the door on its hinges in the open
Figure 5.
Figure 6.
