12
FOOD COMPARTMENTS
3.
LOWER FOOD COMPARTMENT
The lower food compartment may be used for
fresh food storage, or frozen food storage (de-
pending on temperature setting). Ice may also
be made (with ice tray) in frozen food (freezer)
mode.
See “C. Temperature (Thermostat) Con-
trol” on page (9).
The following points apply to storage of frozen
food:
●
To help prevent food from drying out, keep
food in covered dishes, containers, plastic
bags, or wrap in aluminum foil.
● Meat or fish (raw or prepared) can be stored
approximately 3 times longer when frozen
(compared to fresh food storage).
●
Wipe excess moisture off items to be frozen.
Otherwise, frost buildup and reduced effi
-
ciency could occur.
B. Shelving
1.
REMOVE SHELF
a.
Remove shelf lock from shelf. See (FIG. 5).
I.
Insert tip of flat bladed screwdriver into
slot of shelf lock.
II. Turn screwdriver (counter-clockwise),
and remove shelf lock from shelf.
III. Repeat steps (I) through (II) for each shelf
lock (on shelf to be removed).
FIG. 5
Shelf Lock
Twist To
Remove
Shelf
Shelf Bushing
b. Remove shelf from refrigerator. See (FIG. 6).
I. Slide shelf to the left until shelf bushings
(right side) disengage from refrigerator
wall indents.
II. Tilt right side of shelf at an angle (up or
down).
III. Slide shelf to the right until shelf bushings
(left side) disengage from refrigerator wall
indents. Then remove shelf.
FIG. 6
Shelf
Shelf
Bushing
Wall Indent
c. Repeat steps (a) through (b) for each shelf
to be removed.
2.
REPLACE SHELF
a.
Replace shelf in refrigerator. See (FIG. 6).
I. Choose desired shelf height position.
II. Tilt right side of shelf at an angle (up or
down) and align shelf bushings (left side)
to refrigerator wall indents.
III. Slide shelf to the left until shelf bushings
(left side) fully engage refrigerator wall in-
dents.
IV. Tilt right side of shelf at an angle (up or
down) until shelf bushings (right side)
align with refrigerator wall indents.
V. Slide shelf to the right until shelf bushings
(right side) fully engage refrigerator wall
indents.
b. Replace shelf lock on shelf. See (FIG. 5).
I. Place open end of shelf lock onto left side
of shelf (next to shelf bushing).
II. Push down until shelf lock snaps in place.
III. Repeat steps (I) through (II) for each shelf
lock (to be replaced on shelf).
C.
Baskets
1. REMOVE BASKET
a.
Pull drawer open. See (FIG. 1).
b. Locate tabs at front edge of basket and press
tabs outward. See (FIG. 7).
c. Pull basket forward.
d. Lift basket to remove.
Rear basket is
NOT
removable.
