- 8 -
For optimum performance, please place
4.
your wine cellar far away from any source
of heat, e.g. radiator, cooker or intense
sunlight.
Check that the charcoal filter is in place at
5.
the top left corner inside the wine cellar.
Fit the door handle to the door, see
6.
Appendix B
.
Attach the drip tray on the back. The
7.
screws are already attached at the back.
installation
Please follow these instructions:
For best performance, air needs to circulate free
-
•
ly over the cooling unit behind the wine cellar.
The free-standing design of the cellar means that
•
it should stand at least 25 mm (1”) from the rear
and side walls.
Allow a clearance of at least 100 mm (4”) above
•
the wine cellar.
Note that it must be possible to open the wine
•
cellar door at least 90° to allow the sliding
shelves to be pulled out.
Remove the transport pallet on which your
1.
wine cellar rests.
Adjust the feet to allow a 30 mm (1.2”)
2.
clearance under the wine cellar and verify
that it stands in a vertical position in both
directions. If necessary, use a spirit level.
Attach the distance bar using the two
3.
screws at the top back on each side of the
cellar. The bar ensures the correct distance
to the wall behind.
Distance
bar
30 mm (1.2”)
25 mm (1”)
25 mm (1”)
Rear
Wall
Wall
Distance
bar
