EN
Using the extractor hood
CK2000
14
I
➤
Allow the grease filter to dry gently.
➤
Place the grease filter back in the extractor hood.
➤
Fold the cover up and fasten it using the two screws.
7.5
Changing the active carbon filter
The many small pores in the active carbon form a very fine filter. Over time, the
effectiveness of the active carbon filter decreases, as the small pores in the active
carbon gradually become clogged. The active carbon filter should be cleaned every
six months when subject to normal use.
The active carbon filter is fitted on the grease filter.
➤
Remove the two screws (fig.
2
1, page 4) on the cover (fig.
2
2, page 4) and
remove it.
➤
Remove the filter holder from the device (see chapter “Opening the extractor
hood” on page 12).
➤
Unclip the filter holder (
1
) at the points marked (fig.
4
, page 5).
➤
Remove the active carbon filter from the holder and replace it with a new one
(fig.
9
, page 7).
➤
Fit the filter holder and clip it into place.
➤
Fit the cover back into place and fasten it using the two screws.
7.6
Replacing the lamps
➤
Remove the two screws (fig.
2
1, page 4) on the cover (fig.
2
2, page 4) and
remove it.
➤
Remove the filter holder from the device (see chapter “Opening the extractor
hood” on page 12).
➤
Unclip the filter holder (
1
) at the points marked (fig.
4
, page 5).
➤
Carefully pull the lamps out of the socket.
NOTE
A number of dishwasher detergents may cause permanent discolour-
ation of the surface. However, this has no effect on the functionality of
the grease filter.
CK2000-IO-16S.book Seite 14 Donnerstag, 23. März 2017 5:26 17
Summary of Contents for CK2000
