Dometic CK2000, Operating Manual

Page: 12 / 152

EN
Installing and connecting the extractor hood CK2000
12
6 Installing and connecting the extractor
hood
6.1 Note on the installation position
!
6.2 Opening the extractor hood
➤
Remove the two screws (fig.
2
1, page 4) from the cover (fig.
2
2, page 4) and
remove it.
The filter holder (fig.
3
2, page 4) and the device (fig.
3
1, page 4) are held
together by metal clips (fig.
3
3, page 4) on the two front corners.
➤
Unclip the filter holder by pulling the filter holder and the device apart at the
points marked.
➤
Remove the filter holder (fig.
4
1, page 5) at the points marked.
6.3 Connecting the power to the extractor hood
➤
Connect the extractor hood to the battery using the terminal at the rear of the
device; see fig.
5
, page 5.
Connect the following wires: Red to red and black to black/blue.
6.4 Fastening the extractor hood in place
➤
Position the extractor hood under the wall-mounted cupboard and fasten it in
place using the four screws provided (fig.
6
, page 6).
➤
Fit the filter holder and clip it into place.
➤
Fit the cover (fig.
7
2, page 6) and fasten it using the two screws (fig.
7
1,
page 6).
WARNING!
•
It is best to install the extractor hood above the cooking area and
integrate it into a wall-mounted cupboard, where possible.
•
The distance between the gas hob flame and the extractor hood
must total at least 65 cm.
CK2000-IO-16S.book Seite 12 Donnerstag, 23. März 2017 5:26 17