31
Dometic CA1000
Installation
7.3.1
Start and end configuration mode
The adjustable parameters can be altered in edit mode:
➤
With the system switched off, press the
ON/OFF
button (fig.
e
1,
page 6)
.
➤
With the system switched on, hold down the
ON/OFF
button for at
least 2 seconds.
➤
Then hold down the
Mode
button
(fig.
e
4, page 6) for at least 2 sec-
onds.
➤
Let go of the
ON/OFF
button.
✓
The
Compressor
LED (fig.
e
3, page 6) flashes.
➤
Let go of the
Mode
button.
✓
You are now in configuration mode.
✓
The first digit of the display (fig.
e
5, page 6) shows the menu level
and the second and third show the parameter which can be set – e.g.
1.17
for menu level 1 and a set value of 17 °C.
I
Note
If you make no entry on the control panel for 60 seconds, the system quits
configuration mode.
➤
Press the
ON/OFF
button to quit configuration mode.
7.3.2
Menu level 1: Set temperature
The system always starts with a defined value for the room temperature.
This parameter can be configured between 17 and 30 °C:
➤
Start configuration mode (see chapter “Start and end configuration
mode” on page 31).
✓
The first digit of the display (fig.
e
5, page 6) shows the menu level
and the second and third show the parameter which can be set.
➤
Press the
Mode
button (fig.
e
4, page 6) to change the parameter.
➤
Use the
+
and
–
buttons (fig.
e
6 und 7, page 6) to select the temper-
ature (in °C) with which the system starts.
✓
The digits in the display flash until the parameter you enter is con-
firmed.
➤
Press the
Mode
button (fig.
e
4, page 6) to confirm your entry.
✓
The set value is saved and is then used when the system is restarted.
✓
You are now in menu level 1 and can use the + and - buttons to switch
between menu levels.
_IA_CA1000.book Seite 31 Freitag, 30. Januar 2009 11:12 11
