14
Installing unit with 3308120.XXX Genesis Air Filtra-
tion System Return Air Kit. For 3105007.XXX or
3105935.XXX Return Air Kit See Page 13.
Note: On models equipped with a solar panel, see wiring
instructions for the solar panel before proceeding.
1.
Install the slider in the return air cover and raise it
to the ceiling template. See FIG. 29.
2.
Route the wires from the return air cover through
the template slot leaving about 3" between, and
position wire here so they can be reached after
plastic cover is installed. See FIG. 23.
3.
Place the front of the return air cover against the
ceiling and slide towards the rear. The flange on
the ceiling template will catch in the groove on the
return cover. Adjust the position (right to left) and
install the front two screws. Start and tighten the
remaining screws to hold it in place.
4.
Connect together the wires from the thermostat,
control box and filter indicator.
a.
Connect the red wire from the air conditioner
and the red wire from the filter indicator light
with the red positive 12VDC supply wire. See
FIG. 23.
b.
Connect the black wire from the air conditioner
and the black wire from the filter indicator light
with the black negative 12VDC supply wire.
See FIG. 23.
Note: Number 10 cabinet screw can be used to replace the
two front screws to hold the plastic cover flush to the ceil-
ing, if required.
5.
Tighten the screws holding the return air cover. Slide
the filter from the right side (looking toward the RV
front) over the wires. Make sure the wires are se-
cured above the filter and are out of its way.
6.
Place grill on return air cover and snap in place.
Decal is on end over circuit board.
7.
Place slide handle through slots in grill into the
slide posts. Handle will fit in either direction.
Micro-Therm Filter System
Micro-Therm Filter System
FILTER
RESET
FILTER
RESET
CLEA
N
FILTE
R
CLEAN
FILTER
Return Air
Cover
Grill
Foam
Divider
Ceiling
Template
Slider
Filter
Handle
FIG. 29
620615, 620625 & 620626 Installation & Operating Instructions
8.
This completes the installation of the air conditioner.
We recommend that power be supplied to the air
conditioner and check for proper operation. Refer to
Operating Manual or User's Guide for a description
of the air conditioner operation.
