Dometic GROUP WAECO 9102000024, Installation And Operating Manual

Page: 30 / 224

EN
Mounting the camera PerfectView CAM60ADR
30
To make and test the electrical connection , the following tools are required:
 Diode test lamp (fig. 1 8, page 3) or voltmeter (fig. 1 9, page 3)
 Insulating tape (fig. 1 11, page 3)
 Cable bushing sleeves, if necessary
To fasten the cables you may require additional cable binders.
8.2 Mounting the camera
!
I
Observe the following installation instructions:
 To provide a suitable viewing angle, the camera must be attached at
a height of at least 2 m.
Ensure that you have a firm place from which to work when mounting
the camera.
 Ensure that the installation location of the camera is sufficiently firm
(e.g. to prevent the camera from being knocked down by branches that
may brush over the roof of the vehicle).
 Mount the camera bracket horizontally and in the middle of the rear of the
vehicle (fig.
8 , page 6).
CAUTION!
Select a location for the camera and attach it so securely that
it cannot under any circumstances fall off and injure bystanders
(e.g. by being knocked off by branches brushing over the roof of
the vehicle).
NOTE
If installing the camera alters the vehicle height or length specified
in the vehicle documents, your vehicle must be inspected by the
appropriate authorities.
Make sure that you are in possession of documents verifying that
your vehicle has passed this inspection.